Congratulations on your purchase of Easy Welding Rods.

Haven’t purchased yet? Click here and do so.

The Easy Welding Rods are a high-quality special Aluminum-alloy rods used to weld/braze primarily Aluminum and Aluminum alloys, but can be used to braze any other non-magnetic metals except for stainless steel.

The procedure of usage consists of a few simple steps that have to be done properly in order to get a well done weld.

The surface to be welded should be metallurgically clean, meaning it should be free of any free electrons and ions. Don’t panic, it’s easy to achieve, we’re getting close to it. Also, the aluminum forms an oxidation layer on it’s surface, thus protecting the lower layers of oxidation, and we don’t want this layer on the welded surface in order to get a good weld.

This is easily achievable by brushing with a stainless steel brush just before heating. Brush it vigorously, and start heating. It’s a good idea to also do a quick brush while heating and before applying the rod, as this will remove any newly formed oxidation layer and easily create a more rough surface, so the rod material can stick better to the surface of the welded part. The more you brush it when the required temperature is achieved, the better the connection (penetration) into the base metal will be. However, several strokes are usually enough to do the job.

Use a heat source to heat the base metal (we don’t apply the rod yet). You can use a LP gas torch, but MAPP Gas is a perfect choice. The more heat the torch can develop, the better and quicker the base metal can be heated.

If you’re welding two pieces with different thickness, try to heat them equally by applying more flame to the thicker piece.

When you feel the required temperature (728°F / 387°C) is developed on the base material, do a few strokes with the brush, keep the flame on the base metal, and test if the rod melts (if welding different thickness pieces, test with the thicker piece as it builds heat harder). When the rod starts melting from the base metal, do a few more strokes with the stainless steel brush, and then apply the rod.

When finished, remove the flame and let it cool down. It will harden in a matter of seconds, but let it cool down naturally (i.e. don’t immerse in water etc.) so the joint will stick well to the base metal.

That’s about it. If done properly, you have a sound joint, stronger than aluminum.

Notes:
1. When welding/brazing thicker (or larger) parts together, it’s a good idea to use another heat source to preheat the welding area. You can use a kitchen stove or another (standalone) torch that will constantly help keeping the heat to the area of interest.
2. Before brazing/welding for the first time, it’s a good idea to practice on a can or other scrap piece of aluminum, so you get the feeling of this brazing/welding method.
3. Always remember – metallurgically clean surface is the key to a well done weld.
4. Being in control of the heat is important, but also can be tricky.